JH-820 Concrete Sealing Additive
JH-820 can be added to 25% water ratio to make mortar when preparing cement, concrete, plaster, etc. It can also be applied to dry concrete, plaster, gypsum, and wood-like mineral surfaces.
After use, it provides structural insulation by increasing water impermeability on concrete and mineral surfaces. This prevents corrosion and moisture within the concrete.
- It penetrates into the concrete and provides repair on the surface.
- It is solvent-free and odorless.
- Does not contain VOC.
- Because it is transparent, it does not change the structure of the surface.
- It is UV resistant.
- Can be applied with a spray roller.
- Drying time is short.
Areas of Use:
- On concrete surfaces
- Building plastered or natural stone surfaces
- In screed and floor concretes
- Natural stone and similar flooring
- Untreated surface coatings
- Precast facade cladding and surfaces
- On betopan and plaster coating surfaces
- In bricks and briquettes
- On Yutong and pumice surfaces
- It can be applied to untreated natural wood surfaces.
Application to Surfaces: This is a ready-to-use solution. Surfaces must be cleaned of dust and dirt before use. Application can be done using a spray pump or roller at a rate of 200 grams per square meter. Two coats are recommended. Surfaces must be absorbent.
The product is for professional use. Before use, pay attention to the safety warnings on the packaging and, if necessary, refer to the product's Material Safety Data Sheet. Do not inhale, avoid contact with skin and eyes, do not swallow, and use appropriate work safety equipment. Take the necessary precautions to prevent fire and explosion hazards and environmental contamination. Apply in well-ventilated areas.
The product should be stored between +5ºC and +35ºC. The product should not be exposed to direct sunlight. Once opened, store the product in its original packaging with the lid tightly closed.